Request Information
To send your information to Tsubaki, press this button
ATC CHAIN HP-T TYPE WITH TOOL HOLDER
HP-T type ATC chain is based on the HP type with steel tool holder. The inner diameter of the pin is tapered and a retaining function is installed on the pin.
Economical: Additional installation of the tool holder is not necessary.
Accurate holding: As the tool holder is combined with the chain, backlash is reduced.
Compactness: Pin outer diameter and link plate width are smaller than those of HP type.
1) U.S. Tsubaki standardized ATC chain is designed with pull stud, key, number plate and plastic sleeve. An engineering plastic sleeve is fitted to prevent contact with the metal taper parts and protect the shank from being scratched.
2) Attachment chains other than the listed ATC chain line-up are also available to satisfy your special requirements.
Unit of Measure

Specifications

Shank Number

 N/A 50

P - Pitch

 N/A 5.512

R - Roller Diameter

 N/A 3.228

W - Width Between Roller Link Plates

 N/A 3.228

T

 N/A 0.248

H

 N/A 4.252

L1 - d

 N/A 2.750

L1 - MAS

 N/A 2.427

L1 - ISO (A)

 N/A 2.421

L1 - ISO (B) ANSI CAT

 N/A 2.569

L2 - MAS

 N/A 3.242

L2 - ISO (A)

 N/A 3.051

L2 - ISO (B) ANSI CAT

 N/A 2.628

Chain Weight per Pot

 N/A 8.600

Extracting Force

 N/A 77 to 99

Information

N/A The HP-T series is the hollow pin type chain complete with tool holder. Since the chain can bend backward, freedom of layout is exceptional, and a large number of tools can be held in a small space. Tools are held on the pitch line of the chain providing